For those of you who are planning to have your own high pressure washer, there are a number of ways to use a high pressure washer that you need to know. This type of cleaning tool also has several ways to use it that need attention. In addition to avoiding misuse, it is also important that you can use this machine with the proper function to prevent unnecessary damage.
This tool, which is designed to speed up and simplify the washing and cleaning process, is actually quite easy to use. Here are some ways to use a high pressure washer that you can read and pay attention to.
1. Electric pressure must be in a stable state
How to use the high pressure washer requires you to make several checks and adjustments before starting. Not only checking the condition of the machine to be used, but also checking the power or electric pressure at the place where you will use the machine.
Make sure that the electric pressure is always in a stable condition. This is because this high pressure washer machine requires a large amount of electric power. With stable electrical conditions, the use of machines is safer and does not have the potential to interfere with the existing electric flow system.
2. Use clean water and maintain a water supply
Apart from checking the electric pressure, it is also important to check the existing water supply. Make sure there is an adequate source of clean water during the cleaning process. The water supply used cannot be taken from a bucket or water reservoir, but must use running water.
It is also important to ensure that the water used is clean water. In this way, you can also ensure that the dirt to be cleaned can be completely removed.
3. Turn on the engine and see the water condition
After confirming these two important things, the next way to use a high pressure washer is to start the engine and check the water condition or the condition of the spray. The water that enters this machine will flow into the pump to fill the engine. Initially the water spray that comes out may be choppy, so please wait until the water spray becomes smooth.
After that, you can start doing the cleaning process. Also, make sure the hose is completely broken down so that the water that comes out is even smoother and doesn't get clogged or broken due to too high pressure.
4. Body position and how to hold the head gun
Paying attention to body position is also important, including maintaining the correct position when holding the head gun and shooting water. Since the pressure from the water spray that comes out will be very tight, it is possible that the head gun that is not held properly will pop out of your grip. So make sure you do it right.
Position your body upright and position the gun head on the side of the body that is most dominant. The goal is to compensate for the impulse of water and objects being cleaned. To adjust the water pressure and spray width, there is a lance section on the head gun that you can turn. Rotate the lance slowly to adjust the spray size to your needs.
5. Remove air and water pressure once done
The last way to use a high pressure washer is to remove the air and water pressure once you are done with the cleaning process. Given that the way this high pressure washer works is by adding air pressure to push the water out, then you also need to get this air pressure out again.
This air pressure is confined in the jet engine tube as well as the nozzle gun which is removed by opening it so that the air pressure does not damage the seal part of the nozzle gun as well as the engine itself. Clean the machine from excess water and dirt if any. Make sure the machine is dry when it will be stored again.
If you already know and understand some of the methods above, you shouldn't hesitate to immediately have your own high pressure washer machine. Also, make sure you read the complete information on how to use the high pressure washer in the booklet or manual that came with your purchase of this machine.
